Pyramid Time Systems 2650 Podręcznik Użytkownika Pobierz pdf (Strona 14)

AUTO ALIGNING TIME CLOCK INSTRUCTIONS

Model 2650

12 888.479.7264

Prior to removing old ribbon, press button 4 & hold for approximately 6 seconds

to park ribbon in center position.

Unplug time clock.

To remove old ribbon, pull two white clips towards you & simultaneously lift

ribbon cartridge, pull straight up using tab located on top of cartridge.

Remove new ribbon cartridge from packaging & turn the manual ribbon advance

knob clockwise to straighten ribbon.

Holding tab install ribbon cartridge into print carriage, making certain to

lower the ribbon in front of the ribbon guide rst, then make certain

retaining pins are within clips (see diagram).

Gently push down cartridge until it snaps into carriage while turning the manual

ribbon advance knob clockwise.

Turn manual ribbon advance knob clockwise a few rotations to ensure ribbon is

positioned correctly in front of print head.

Replace the cover & lock unit.

Feed a time card through unit to test print quality.

REPLACING RIBBON CARTRIDGE

For optimum performance, the ribbon cartridge should be replaced every 6 months.

If time clock prints incomplete characters, the ribbon is not fully installed over print

head. If time clock prints lines that become increasingly light, the cartridge is not

fully snapped into the holder. Reinstall ribbon cartridge, following steps 1-7 until a

complete & consistent time card prints.

For assistance, please contact customer support at 888.479.7264 ext 1.

REPLACING RIBBON CARTRIDGE

Select

1 2 3 4 5 6

A – Ribbon Cartridge C – Tab E - Manual Advance Knob

B – Clips D – Ribbon Guide F – Retaining Pins

1 2 ... 9 10 11 12 13 14 15 16 17 18 19

Brak uwag

Pyramid Time Systems 2650 Podręcznik Użytkownika Strona 14